Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Fresno Owner’s Guide

We stock and install Ghost Controls-compatible keypads and intercom modules across Fresno, and a typical keypad replacement runs between $160 and $310 installed, depending on the model and whether the mounting post or wiring also needs attention. Most jobs are completed in a single visit, and if you call before 2 p.m., we can usually get a technician out the same day. The way owners usually discover this failure is quiet: the keypad still beeps but the gate won’t move, the intercom buzzes but the voice is gone, or the keypad works from one side of the driveway but not the other. You punch the code three times, then walk back to the house for the remote, and that is the moment it stops being a nuisance and starts being a repair.

Call (559) 785-2501

Which Ghost Controls Models This Applies To

Ghost Controls builds keypads and intercom modules for their automatic gate opener systems, and the compatibility picture is not one-size-fits-all. The most common units we service in Fresno are the Ghost Controls wired keypad (which mounts on a gooseneck post or wall plate) and the wireless keypad that pairs directly to the control board. Older systems from before the Ghost Controls branding transition, sold under the GTO/PRO name, often have interchangeable mounts but not interchangeable wiring harnesses. The practical takeaway: match the keypad by the wire count and the control board revision, not just by brand name. A Ghost Controls keypad with a four-wire harness is not a drop-in for a five-wire board, and we have seen that mistake turn a $200 repair into a $500 board replacement. The label inside the battery compartment or on the back of the keypad housing is where the real identification lives. We bring both OEM Ghost Controls parts and quality aftermarket equivalents on the truck, and we walk you through the difference before we install anything. For the record, Latch and Post Gate Repair Fresno is an independent service provider; we are not affiliated with Ghost Controls.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• The keypad beeps and lights up, but the gate doesn’t move. This is almost always a failed output signal from the keypad to the control board, or a worn relay on the board itself. The keypad is the part you see, but the failure may sit one connection deeper.
• The intercom picks up sound, but the other side can’t hear you. On Ghost Controls intercom modules, the microphone or the weather sealing around it fails first, especially after a few Fresno summers with dust and triple-digit heat cycling the housing.
• The keypad works intermittently, worse in rain or cold. Moisture intrusion into the keypad housing is the usual cause. The rubber membrane degrades, a hairline crack forms, and condensation shorts the circuit until it dries out.
• You have to press the buttons harder or multiple times. The tactile switches under the rubber key overlay wear out from UV exposure and repeated pressing over years of use. This is a mechanical failure, not a programming problem.
• The intercom rings but the voice sounds scratchy or distorted. Corrosion on the wiring terminals or a failing speaker cone on the intercom unit is the typical culprit, often after water wicks up the wire from the post base.

Replacement Cost & What’s Included

For Ghost Controls keypad replacement in Fresno, you are looking at $160 to $310 installed for most residential setups. Intercom modules run slightly higher, usually $210 to $340, because they involve more wiring and often require the post-mounted speaker to be reseated. Here is how that breaks down:

• Keypad unit (OEM or equivalent): $70 to $140
• Intercom module: $110 to $180
• Labor and wiring verification: $90 to $130
• Weather sealing and mounting hardware: included in labor

Every job starts with a written price before any work begins. No exceptions. We hand you the number, explain what it covers, and if you say yes, the technician gets to work. If you say no, we pack up and leave, no pressure. The work itself is covered by the 365-Day Done Right Promise, which means if the keypad or intercom fails within a year due to our installation, we make it right. And while we are on site, we check the wiring and the control board connections, because a Ghost Controls keypad rarely fails in isolation.

DIY or Call Us?

There is one thing you can safely check before calling: the wiring at the keypad and at the control board, if you can reach it without opening the board housing. Look for visible corrosion, a loose terminal screw, or a wire that has pulled free. Beyond that, Ghost Controls keypads and intercoms run on 12 to 24 volt low-voltage circuits, so the shock risk is minimal. The real risk to a DIY approach is misdiagnosis: you replace a perfectly good keypad because the control board relay was the actual failure, and now you are out $140 and the gate still won’t open. We see that pattern often enough that it is worth saying plainly. If the keypad beeps but the gate doesn’t respond, the keypad may be fine. Call (559) 785-2501 and describe what you are seeing. We will help you figure out whether it is worth a service call before you spend a dollar on parts.

FAQs